Construct A Professional And Rewarding Website In 1 Hour
The strength of the frame can be an illusive thing unless you know a bit about strength of materials and actually how to calculate the cracking stress and bending deflections. Usually what we do is: "If in doubt make it stout." That is a nice adage but it can be detrimental to a go kart design. You can end up throwing a lot of steel at a section of the go kart and actually not get any headway. So analyzing the frame prior to actually putting it together is a good idea. The last thing you want is a frame that snaps in half, or cracks in the middle.
overhaul a care engine The two words that 90% of my customers would always cringe at were "oil leak." There are different grades on just how bad or how urgently an oil leak needs replacing. I'm not going to get extremely technical, but I will give you some facts that I hope empower you the next time you get quoted with an enormous "car maintenance needed" sheet of paper by your service advisor.
When the engine is smoking while the engines is just sitting idle, that means there is severe blow by on the rings of the engine. The engine will not last much more than 10-15 hours with this type of oil blow by. Significant internal engine modifications will be required, which will include: ring replacement (at a minimum) and reboring the cylinder.
build a car engine Water is a very inexpensive fuel. The cost that needs to be invested is for detailed plans of how to convert your car to a car running on water, $67. Then the materials will set you back around $170.00.This is a very small investment for the savings that will be reaped in the coming weeks.
Translation: the engine can not crank out 5000 rpms to get it engage. The engine only operates as 3600 rpms max. If so the clutch actuates at a higher rpm and therefore the camming action does not occur quick enough and causes the pulleys to slip and generate heat on the pulleys and burn the belt.
rebuild a car engine When I was designing go-karts I grew tired of having to calculate the drive line systems, so I put together a computer program and had it calculate for me. I made it pretty fancy at one point where you could insert horsepower and get out how insanely fast the go kart would go. Or I could do time trials with my go kart and calculate how much power my go kart actually had. So bottom line is do some sort of drive train analysis, or calculation.
As well as things that you know may need fixing, there is always the unexpected. A spray nozzle came loose from the carby in my bay window and went through the engine. It's only a small thin brass tube but it sounded as though there were marbles rattling around in the engine. Luckily there was no damage, CA income tax rate 2019 but it did mean pulling out the engine and taking off the cylinder heads to check everything and to remove the remains of the spray nozzle. And just this week I've had to replace the alternator.
